Posted by grandpajohn on October 28, 2012 at 21:40:20 from (4.252.212.180):
In Reply to: 1070 dosnt want to run posted by grandpajohn on October 27, 2012 at 22:07:41:
Thanks for all the replys. I think I have narrowed it down to the transfer pump. I have good flow to the tansfer pump. I have replaced the filters and bled them all out. When I remove the line from the transfer pump to the filter there is no fuel being pumped when the engine is running, but If I hand pump it then fuel comes out.
I will talk with the injection pump guy tomorrow, I really dont want to take the pump off if I dont have too.
thanks gramps
PS I wanted to use it for my plow day but it just didnt want to co-operate so it sat at home and the other trators got to plow more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.