Posted by Steve Cundiff on September 24, 2012 at 04:33:56 from (18.104.22.168):
In Reply to: Re: case 1294 posted by RGMartin on September 24, 2012 at 04:06:54:
Dont know about the thickness, maybe 3/8", not quite 1/2". Not installing one bolt, there is a threaded stud at the bottom that stays in place, the yes putting gasket in the grove in water pump, then rotating in place. It did not take any force at all to get the gasket in place though, went right where it should be with no problem or force, but I did put a waterey soapy solution on it first. Does this help you with my problem??? Thanks for your help.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.