Allis Chalmers Discussion Board|
Alice Chalmers 5040 pto
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by bighead on July 02, 2006 at 20:14:33 from (184.108.40.206):
My inlaws have an alice-chalmers 5040 that that mainly use to run a bushhog. To make the PTO work, we have to shift the pto lever into gear and start the tractor that way- the pto turns all the time. My father-in-law says that the PTO used to disengage when you pushed in the clutch pedal, but not anymore. How is this tractor set up internally? Does that clutch pedal release two clutches? Is there possibly some linkage that I could adjust?
I"m a mechanic at a Deere dealership, so I"m pretty familiar with tractors, but I"ve never messed with an alice chalmers much. Thanks for any advice.
|Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]|
| Copyright © 1997-2016 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters