Allis Chalmers Discussion Board |
Re: Allis Chambers wd 40
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John (MO) on July 28, 2005 at 11:14:01 from (198.209.172.95):
In Reply to: Re: Allis Chambers wd 40 posted by John (MO) on July 28, 2005 at 11:07:16:
You can add on a single acting hydraulic remote with out much problem. Depending on the size of the hydraulic cylinder you are using then, the system should operate it ok but maybe a little slower that you would like. As I said the system is high pressure, low volume instead of low pressure, high volume of more modern tractors. If that will work the cylinder you want to run, it shouldn't hurt it unless you let the pump keep pumping more and more pressure against a fully extended cylinder. If you do that, something may blow.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|