Allis-Chalmers Discussion Board |
'39 Model B Can't open the choke.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jake on July 13, 2001 at 14:11:50 from (141.151.229.21):
I just had to replace the front cam bearing, after putting everything back together, I can't keep it running after I try to open the choke. It starts just fine and I can crack open the choke just a little, any more than that, it shuts off. All the timing marks lined up. Is it possible to get the cam gear on 180 degrees off?? If so, will it cause a situation like this? If not, what else can I look for. I looked for air leaks with propane, I had the carb rebuilt by a dealer, I checked ignition. It almost acts like it's running out of gas, so I even put a larger diameter gas line on it. I'm lost and out of ideas.
Follow Ups:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|