If the tractor will not fire when you spray ether or gas directly into the cylinders you just about have to have a spark/timing problem. Out of curiousity have you tried putting any of the old parts back in? As Old stated some things are better left alone. I have had new parts be bad directly out of the box. If you have not already done so, I would put the old condenser and plugs back in and see if that improves anything. What brand were your old spark plugs? AC Delcos are a resistor type plug that are not recommended for a points ignition system, you need a non resistor plug. I have personally had it where resistor plugs would spark enough to keep the plug dry but not enough to properly ingite the fuel, I changed to a nonresistor plug and the engine fired right up. Both were new sets but only one agreed with the engine.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.