A good source with pictures of S/N locations is http://people.clemson.edu/~wsmth/SNLocat/ACSN.htm
D17 Tractor S/N should be on flange where transmission mounts to engine on drivers left side if I recall. Engine S/N should be on block in flat space behind carb. Motor s/n should start 17- and have a letter suffix. Both S/N will be steel stamped into the metal - not raised - the raised numbers relate to the casting.
WD and WD45 S/N should be on rear of tractor axle brake housing area - again on drivers left and both should start WD followed by up to six digits. Some early WD had S/N on top at edge of (possibly under) left brake cover. WD were under 146606 and WD45 started at 146607. Motor S/N same as D17 except it should start with W or WD for the 201 ci WD motor or 45- for the 226 ci WD45 motor.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.