Posted by Paul from MI on October 15, 2013 at 19:40:47 from (22.214.171.124):
In Reply to: sickle mower posted by dahlin 1 on October 13, 2013 at 05:18:31:
Originally there were two tapered cast spacers to level the drawbar mounting surface. Not sure they were necessary, but they came with the mower. Use washers as shims to get the drive belt tight. Leave the center brackets that bolt to the foot rest cross bar loose until you get the belt adjusted, then tighten. Good mower to use, horrible to put on&off, repair record was lousy. We kept the local welder busy with ours--I still have it.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.