Posted by willie in mn on September 23, 2013 at 18:21:46 from (64.12.116.205):
In Reply to: d14 3 point problem posted by todd hartman on September 22, 2013 at 18:07:34:
I have been wrong before, & probably wrong this time too. IIRC, the top link should be parallel with the lower links, or even a bit lower in front. To save a lot of cutting, welding, bending etc, make a 4 sided mock up out of scrap 2x4 lumber. Match as close as possible the dimentions of the lower links, top link, height distance between lower & top pins on mower, same on tractor. Put just one nail at each joint. Move it around to simulate lifting action, then adjust tractor end of top link pin(nail) to get desired results. Willie
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.