Posted by Drak on February 24, 2013 at 01:18:53 from (37.240.188.166):
In Reply to: Re: Belly mower posted by old on February 23, 2013 at 15:14:59:
I think I have found the solution, rather than modify the brackets to bring the mower back to allighn the pully i can machine an adaptor to fit between the pully and the shaft on the mower, its possible there was one there origonaly which would explain the miss match, but it does not show one in the manual.Broken PTO shaft would not be the issue as its the shaft on the mower that is not long enough not the PTO shaft thats two short. By the way I dont know if you remember but we had a disscussion back in the summer about fitting a diesel engine to a "C" well i have obtained a Perkins P3 and have now modified it to fit, I managed to find an old perkins diesel engine (scrap) off an AC B (they produced a few in the early 50ties) not many and they are very rare to find, i have taken the sump, oil pump, fly wheel, clutch, and bell housing off the junk AC engine and fitted to my new Perkins P3 so its ready to install, but i need to wait for better weather. I will post pictures when i finaly get it done.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It's Alright Where It Is! - by Anthony West. I have a tale of a different kind to tell. Whilst rooting in the hedge bottoms this week I had cause to visit Chapel lane Farm, the home of an eccentric gentleman by the name of Austin Kendall. I had heard rumours that an old Case Model C was languishing away in the back of one of the outbuildings there. So off I went in search of what would turn out to be a very rare and unusual tractor. Mr Kendall is an excitable chap to say the least. He is amongst the last of a dying breed of farmer who
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
