Posted by Dick L on December 19, 2012 at 11:28:18 from (184.108.40.206):
In Reply to: steering box on C posted by Bobby 9891 on December 19, 2012 at 11:09:56:
Does the arm move at the box as soon as you turn the wheel back and fourth? Or is there still slop between the pin and worm gear slot. Did you check the pin at the top, center and bottom to see if the worm was wore in the center? I can make you a larger pin but if the one I sent you is tight at the top and bottom then a larger one would not work as it would bind before you could turn the front as far as it goes right or left. The one I sent you was the laSt one out of a batch of four. The other three worked. Lets make it work one way or the other. Might take a different gear and shaft.
I was in New Boston and Decalb Texas on my way to Idabel Oklahoma at the end of last week. Long ways from you I would guess.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.