Posted by Ralphwd45 on November 18, 2012 at 12:28:37 from (22.214.171.124):
I want to put a new clutch in my wd45, as it slips some. I wanted to remove the grill and radiator, and slide the engine foreward, to clear the jackshaft, instead of removing a side rail, like the IT manual says to do. is it possible? and can I remove the clutch and pressure plate, thru the bottom of the bell housing, like a truck, or does the bell have to be removed first?
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.