Posted by JMS./MN on October 22, 2012 at 14:02:04 from (209.237.125.241):
In Reply to: Gleaner M2 posted by IH 466 on October 21, 2012 at 16:56:29:
I'm biased- been running Gleaners since 1976- 4 of them....K, F, F2, M2. Was tempted to buy a JD 6600 years ago- way better, tougher machine than a 4400. Heavier shafts, bearings, etc. But, working on any combine- Gleaner is the simplest. Others stack 2-3 pulleys on a shaft, so when the bearing goes out, you get to pull 2-3 steel pulleys off ( ruining them) to get to the bearing. Gleaner mostly uses cast pulleys. I've counted the drive belts on a xx00 JD, had twice as many as a Gleaner.
HANDS DOWN- BIGGEST ADVANTAGE WITH A GLEANER IS ROCK PROTECTION FOR THE CYLINDER! No one else comes close with their mickey mouse rock traps! RT fills up and the next one goes into the concave! Gleaner just pops the cyl door open, and it spits out onto the ground. Buzzer/light comes on, you get out and check, close the door, and go!
Still, biggest issue is maintenance- way easier to work on.......look at any Massey if you think the reds or greens are tough to work on.
Local custom operator runs JD but told me Gleaner was a better machine........only reason he switched was for the finance plan from the company.
OK- if you're asking about an older machine....you want something easy to work on, easy to adjust, get a good sample from..........you cant go wrong with a good Gleaner. Just check out which machines are available in your area.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.