Posted by LeonardWD45 on October 09, 2012 at 13:24:38 from (131.191.110.118):
In Reply to: WD45 AND PLOW REUNITE posted by CM BEHOUNEK on October 09, 2012 at 08:26:32:
To gain more depth turn the crank handle in the center of the plow clockwise, more shallow turn counter clockwise.
Is the right hand hook up adjustable, if so lengthen so that the right hand side of the plow will drop down more.
Just remember, when plowing, after the first round your tractor will be at a slight angle with the right hand side running in the previous rounds open furrow, so dropping the r/h share down may make it dig too deep.
As for running out of power, I just completed a complete rebuilt of the engine in my WD-45 with a 4.125 overbore kit and pulling a 3 bottom with 16in spacing in concrete hard ground, I had more power than I could put on the ground and my fuel economy is about 3 times better.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.