Posted by Diydave on October 03, 2012 at 17:22:10 from (96.244.152.82):
In Reply to: I60 govener linkage posted by gary ronkar on October 03, 2012 at 17:06:58:
Your best bet would be to get the AC shop manual. You need to know which engine you have. A 149 uses a round muffler, and a 160 uses an oval muffler. There will be a serial # on the rear left flange, on about a 45 degree angle, of the motor. If you know where the tractor serial# is, its about an inch in front of that #. Once you figure out which motor you have, you can still get the original shop manual from Agco, It'll either be a D-15 series 1 (149CID), or series 2(160 CID). If you want an Agco parts source, try Sandy Lake Equipment, a long time western PA Agco dealer, till agco cut them out recently, Brenda in parts is who to ask for!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
