Posted by Aaron SEIA on September 30, 2012 at 14:32:13 from (126.96.36.199):
In Reply to: AC WD45 TIMING posted by CM BEHOUNEK on September 30, 2012 at 10:01:15:
I agree with JMS, you need to get #1 at TDC on the compression stroke and go from there. Pull the plug (all of them makes turning it over easier). While rolling the engine over with your thumb on the hole for #1, feel for air trying to get past your thumb. That is the compression stroke. Line up the fire mark on the flywheel, then get your wires lined up like the picture I posted.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.